Genie 4042 manual Wall Console - Overview, Indicator Light, Open/Close Button, Sure-Lock Button

This opener has a Serial Number sticker in which the serial numbers begin with 10 or higher.

ATTENTION

If your garage door opener has a Serial Number sticker which looks like this, in which the first two numbers are 10 or higher, your opener will operate using this Series III wall control.

MODEL AC SR3	THE GENIE COMPANY
FCC ID: B8Q AC SR3	Residential Door Operator
IC: 2133A-CSD1D	120V. 60HZ. 5A
S/N:10XXXX XXXXXXX

FOR HE P C L 1 800 35GENIE OR WWW GEN ECOMPANY COM

Follow the instructions on this page.

Wall consoles from other manufacturers may not work with openers of these serial number groups. Genie® Series I wall buttons and Series II wall consoles will not work with openers of this serial number group.

WALL CONSOLE - OVERVIEW

Use only the Series III wall console provided with this unit.

Wall console has three buttons and one indicator light.

Indicator Light

Indicator light will display Red when wall console is properly wired and Sure-Lock™ is OFF. When Sure- Lock™ is ON indicator light flashes.

Open/Close Button

Use this button to open or close garage door. When Sure-Lock™ is ON the Open/Close button will CLOSE door only. Note: Constant button pressure in the CLOSE mode will override error responses in the powerhead and close door.

Open/Close Button

Open and closes door from inside garage

Sure-Lock™ Button

–LOCK disables controls after door is completely closed

–UNLOCK allows controls to

work normally

Indicator Light

Red indicator light is always ON

When Sure-Lock™ is ON the indicator light flashes

Independent Light Control Button

Controls door opener lights from inside garage

Tip: If indicator light on wall console comes ON, but
there is NO	FROM STBs					FROM STBs
operation from				FROM WALL			FROM WALL
buttons - verify				CONSOLE			CONSOLE
wall console
wire routing								NOT	NOT
at powerhead
								USED	USED
connector.
		STB	BWC		IWC	STB BWC IWC

Independent Light Control Button

Use this button to turn powerhead lights ON. Powerhead lighting will remain ON until this button is pressed again or a door action has been completed. Note: If opener has a Motion Detector sensor the sensor will keep powerhead lights ON as long as motion is detected.

Sure-Lock™ Button

When Sure-Lock™ is ON the powerhead cannot be activated by the wall console or a remote.

•Press and hold for 5 seconds (or until Indicator Light flashes) to activate Sure-Lock™.

•Press and release to turn Sure-Lock™ OFF.

OPTIONAL DUAL WALL CONSOLE - INSTALLATION

Use only a Series III wall console when adding a second wall console. The optional second Genie® Series III wall console must be purchased separately.

TO	TO WALL CONSOLE #1
POWERHEAD

FROM STBs

FROM WALL

CONSOLE

NOT	B/W	W	B/W	W
	NOT
USED	USED

STB		BWC		IWC		WALL	WALL
Wire connector
						CONSOLE #1	CONSOLE #2
on Powerhead
						OR
						BOTH TO POWERHEAD
FROM STBs	FROM WALL
	CONSOLE #1
			FROM WALL
			CONSOLE #2
				NOT	NOT
				USED	USED
						B/W W	B/W	W
STB		BWC		IWC
Wire connector on
Powerhead						WALL	WALL
						CONSOLE #1	CONSOLE #2

20 ©2011 The Genie Company 3/2011