Kodak 800 SERIES service manual Y-Arm Installation/Removal

NovaJet 800 Series Service Manual

4.Disconnect the AutoLoad Sensor connector at the J13 location on the Main PWA. Grasp the AutoLoad Sensor connector with the thumb and forefinger and pull straight out.

5.Remove the seven screws that secures the Y-Arm Assembly to the Platen. See Figure 5-28.

Figure 5-28. Y-Arm Installation/Removal.

6.The pinch rollers are held on by a small C clamp located on the back of the Y-Arm Assembly. See Figure 5-29. While holding the pinch roller, remove the C clamp and move the pinch roller towards the front of the Y-Arm Assembly until it clears the back of the Y-Arm Bracket.

Assembly\Disassembly 5-45