Kodak 800 SERIES To remove the Cooling Fan and AC Entry Module, Power Supply Removal

NovaJet 800 Series Service Manual

Figure 5-8. Power Supply Removal.

To remove the Cooling Fan and AC Entry Module:

1.Remove the four screws located below the Right Baseplate securing the Power Supply Bracket to the Right Baseplate. Remove the Power Supply Bracket. See Figure 5-9.

2.Using a Phillips screwdriver and a 1/4” wrench or socket, remove the Fan from the Right Baseplate.

3.Using a 1/4” wrench or socket, disconnect the AC Entry Module ground from the ground stud on the Right Baseplate.

4.Remove the AC Entry Module by pressing in on the securing tabs until the module is released.

Assembly\Disassembly 5-16