Install the E-Connect Network Assembly

NovaJet 800 Series Service Manual

Figure 5-3. E-Connect Assembly Installation/Removal.

3.Put on an ESD wrist strap.

4.Slowly lower the E-Connector Assembly until you can disconnect the power cable from the connection located near the center of the circuit board.

1.Connect the power cable to the connection located near the center of the circuit board.

2.Hold the E-Connect Assembly in place and secure using 4 screws. Torque to 15 in-lbs

3.Connect the small parallel cable and the network cable to the rear of the E-Connect Assembly.

Assembly\Disassembly 5-7