NovaJet 800 Series Service Manual
7.Disconnect the Leg Harness connection at the J6 location by grasping the Leg Harness connector with thumb and forefinger and pulling straight out.
8.Disconnect the Trailing Cable B connection at the J2 location. Use the thumb and forefinger to pull up on the connector lock and remove the Trailing Cable from the connector.
9.Disconnect the Trailing Cable A connection at the J1 location. Use the thumb and forefinger to pull up on the connector lock and remove the Trailing Cable from the connector.
10.Disconnect the Autoload Sensor connection at the J13 location by grasping the Autoload Sensor connector with thumb and forefinger and pulling straight out.
11.Disconnect the Vacuum Fan 1 connection at the J15 location by grasping the Vacuum Fan 1 connector with thumb and forefinger and pulling straight out.
12.Disconnect the Vacuum Fan 2 connection at the J4 location (60 inch model only) by grasping the Vacuum Fan 2 connector with thumb and forefinger and pulling straight out.
13.Disconnect the Power Supply Cooling Fan connection at the J17 location by grasping the Power Supply Cooling Fan connector with the thumb and forefinger and pulling straight out.
14.Disconnect the
15.Disconnect the ground straps going to the side plate and baseplate by removing the screw located near the parallel port on the Main PWA.
16.Using care, remove the Main PWA by unscrewing the remaining screws securing the Main PWA to the bracket. See Figure
Assembly\Disassembly
