Kodak 800 SERIES Install the Paper Sensor or the Encoder Sensor, To install the Paper Sensor

NovaJet 800 Series Service Manual

Install the Paper Sensor or the Encoder Sensor

1

ROUTE FLEX THROUGH SLOT INSIDE THE CARRIAGE ASSEMBLY

ALIGN SIDES	GROOVES
OF PAPER
2 SENSOR
BOARD
BETWEEN
GROOVES
AND PUSH
STRAIGHT
DOWN

1 PUSH DOWN ON CLIP. PUSH ENCODER IN OVER CLIP. ENCODER MUST SLIDE PAST THE RIDGES AND SNAP INTO PLACE

Figure 5-22. Paper and Encoder Sensor Installation.

NOTE

The Paper Sensor and Encoder Sensor are only installed onto the right Carriage. All procedures in this section refer to the right Carriage only.

1.To install the Paper Sensor:

a.Turn the Carriage so that the bottom side of it is facing up.

b.Route the flex on the Paper Sensor through the slot in the Carriage. Make sure the flex cable goes all the way through and does not curl under the Carriage PWA.

c.Grasp the Paper Sensor between thumb and index finger and guide the sides of the board into the grooves on each side of the opening. See Figure 5-22.

d.Push the Paper Sensor board down into the Carriage Assembly until it snaps firmly into place.

Assembly\Disassembly 5-36