Kodak 800 SERIES service manual

NovaJet 800 Series Service Manual

Install the Y-Arm Assembly, Pinch Rollers, Slide Shaft, and AutoLoad Sensor

1.Install the AutoLoad Sensor Assembly into the back part of the Y- Arm Bracket. Torque to 6 in-lbs.

2.Route the AutoLoad Sensor wires through the four wire clamps on the back part of the Y-Arm Bracket.

3.Install the Slide Shaft and its supports to the Y-Arm Assembly. Torque to 8 in-lbs.

4.Insert the back compression spring onto the shaft of the pinch roller and push the back of the shaft through the back of the Y-Arm Assembly. Install the C clamp around the shaft of the pinch roller.

5.While compressing the forward pinch roller spring with a screwdriver (or other flat object), position the pinch roller onto the Y-Arm Assembly until the forward spring is located under the hole in the Slide Shaft. Release the spring and verify that the spring enters the hole in the Slide Shaft and that no kinks are present in the spring.

6.Perform steps 4 and 5 for all pinch rollers.

7.Secure the Y-Arm Assembly to the Platen. Torque to 15 in-lbs.

8.Install the Stabilizer Bracket, Carriage Assembly and Trailing Cable Assembly following procedures outlined earlier in this chapter.

9.Install the Ink Delivery System following procedures outlined earlier in this chapter.

10.Install the Top, Left and Right Covers following procedures outlined earlier in this chapter.

12.Perform the Head Height Adjustment procedures found in Chapter 3 of this service manual.

Assembly\Disassembly 5-47