NovaJet 800 Series Service Manual

Figure 5-10. Using the Belt Removal Tool.

6.Turn the movable side so that the tool begins to expand and the Frame Tensioner Spring compresses. Continue to turn on the Belt Removal Tool until the belt can be lifted off of the Servo Motor pulley.

7.Move the Carriage Belt to the left so it is out of the way of the Servo Motor pulley.

8.Move the Carriage Assembly to the left end of the Slide Shaft.

9.Lift up gently and hold the right end of the Trailing Cables.

10.Remove the back screw on the Servo Motor. The screwdriver will be held at a slight angle.

CAUTION

Be careful not to strip the head of the screw or to cause damage to the Encoder Strip.

Assembly\Disassembly 5-19

Page 223
Image 223
Kodak 800 SERIES service manual Using the Belt Removal Tool