Kodak 800 SERIES service manual Cartridge Identification Chip

NovaJet 800 Series Service Manual

Figure 4-67. Cartridge Identification Chip.

3.It is possible the ID chip on the rear of the cartridge may have slipped from its original position. Verify the double dimples (2 small circles on flex cable) have been penetrated at or near the center of each circle. If not the chip is out of position or is not mating correctly within the carriage assembly. After correcting, reattach cartridge, message should clear automatically after selecting OK.

4.To clear the error, turn the printer off and then on again. Press Utility Menu/Service Menu/Cartridge Info to determine the cartridge for which the error message is displayed. The incorrectly registered cartridge will have two asterisks (*) displayed. Press Utility Menu/Access Menu/Access Right to move the carriage assembly to the service position to allow replacement of the appropriate ink cartridge. Check to make sure you have the correct cartridge for your printer model installed in each position. Install new cartridges if necessary.

5.Reseat both large flat white trailing cables at the Main circuit board if the above steps do not work. Reseat both cables at the carriage PWA’s. Reseat all flex driver cables at rear side of carriage PWA’s.

Troubleshooting 4-64