Kodak 800 SERIES service manual Install Memory Module, Remove the Main Printed Wiring Assembly PWA

NovaJet 800 Series Service Manual

Install Memory Module

1.Slowly push the Memory Module into place. Make sure the module is fully seated.

2.Push the side clips towards the Memory Module until they hold the module securely in place.

3.Install the Top and Right Covers following procedures outlined earlier in this chapter.

Remove the Main Printed Wiring Assembly (PWA)

CAUTION

Integrated circuits may become weakened or damaged by electrical discharge. Do not touch or work near integrated circuits without wearing an ESD wrist strap.

1.Remove the Top and Right Covers following procedures outlined earlier in this chapter.

2.Put on an ESD wrist strap.

3.Remove memory module following procedures outlined earlier in this chapter.

4.Disconnect the Power Supply connection at the J8 location by grasping the Power Supply connector with thumb and forefinger and pulling straight out. See Figure 3-4 for jack locations.

5.Disconnect the Stepper Motor connection at the J7 location by grasping the Stepper Motor connector with thumb and forefinger and pulling straight out.

6.Disconnect the Servo Motor connection (red and blue wires) at the J12 location by grasping the Servo Motor connector with thumb and forefinger and pulling straight out.

Assembly\Disassembly 5-11