NovaJet 800 Series Service Manual
11.Lower the Trailing Cable back into place.
12.While holding the Servo Motor, remove the front screw on the Servo Motor.
13.Lower the motor to clear the platen and carefully bring the motor out of the printer.
Install Servo Motor
1.Reinsert the Servo Motor under the Platen with the connector facing the FRONT side of the Platen. Guide the pulley up through the opening in the Platen.
2.Once the Servo Motor pulley is through the Platen, push up on the Servo Motor and align the screw holes with the screw hole openings.
3.Insert the front screw into the Servo Motor and tighten it almost all the way.
4.Lift up gently and hold the right end of the Trailing Cables.
CAUTION
Make sure the screw does not go into the motor at an angle, and be careful not to strip the head of the screw or to cause damage to the Encoder Strip.
5.Insert the back screw into the Servo Motor and tighten it.
6.Tighten both screws on the Servo Motor to 15
7.Slide the Carriage Belt over the Servo Motor pulley. Make sure that the guides on the inside of the belt are inserted in the pulley grooves and that the belt is not twisted.
8.Turn the Belt Removal Tool to tighten the belt around the Servo Motor pulley.
9.Move the Carriage Assembly back and forth to check the Carriage Belt tension. Remove the Belt Removal Tool.
Assembly\Disassembly
