NovaJet 800 Series Service Manual

7.The Trailing Cable Assembly is secured to the Stabilizer Bracket by two pieces of double sided tape. Remove the Trailing Cable Assembly from the Stabilizer Bracket.

8.Mark the position of the double sided tape on the Stabilizer Bracket before removing. It is important that the new tape is placed in the exact position as the older pieces were. Remove any remnants of tape still on the Stabilizer Bracket.

Install the Trailing Cable Assembly

1.Apply two new pieces of double sided tape to the Stabilizer Bracket. Ensure that the tape is in the same location as the original tape was.

CAUTION

The right side of the Trailing Cable (the side connected to the Main PWA) must extend beyond the Stabilizer Bracket by 5” (4 7/8” - 5 1/8”) or 128mm (125mm - 131mm.)

2.Slip the ferrite around the Trailing Cable Assembly and insert the right side of the Trailing Cable Assembly through the access hole provided in the Right Side plate.

3.Slide the Carriage Assembly and Floating Carriage Cover Assembly to the far left side of the Slide Shaft. While ensuring a 5” (125mm) overhang on the right side, position the Trailing Cable Assembly over the Stabilizer Bracket and slowly lower it onto the bracket. Ensure that the Trailing Cable Assembly goes on straight and that there are no buckles in the cables. Firmly press the Trailing Cable Assembly onto the tape to secure it into position.

4.Connect the right end to the Main PWA, the right Carriage cable (longer cable) to the J1 connector and the left Carriage cable (shorter cable) to the J2 connector.

5.Move the Carriage Assembly and Floating Carriage Cover Assembly to the right. Insert the Strain Reliefs (with Trailing Cables and ferrite) onto the Carriage Assembly by sliding it onto the Strain Relief Supports until it snaps firmly into place.

Assembly\Disassembly 5-42

Page 246
Image 246
Kodak 800 SERIES service manual Install the Trailing Cable Assembly