NovaJet 800 Series Service Manual
Remove the Media Take-Up and Feed Motors
1.Remove all media and media rollers from the printer.
2.Remove the four screws holding the Cradle Idler to the leg assembly. See Figure
3.Carefully slide the Cradle Idler assembly out of the leg assembly until the wires going to the motor can be removed.
4.Remove the wires from the motor.
5.From the back of the Cradle Idler, disconnect the tension spring from the post located on the Cradle Idler.
6.Remove the screw and washer holding the motor mount to the Cradle Idler. Carefully remove the motor, motor mount, and motor gear subassembly from the Cradle Idler.
7.Remove the C clamp that is securing the motor gear to the motor.
8.Remove the three screws, washers, and lock washers from the motor mount to remove the motor.
Install the Media Take-Up and Feed Motors
1.Install the three screws, washers, and lock washers that secures the motor to the motor mount.
2.Install the motor gear to the motor. Secure with a C clamp.
3.Insert the motor, motor mount, and motor gear subassembly into the back of the Cradle Idler. Tilt the subassembly slightly while installing to align the motor gear with the opening on the top of the Cradle Idler.
4.Screw in the screw and washer that secures the motor mount to the Cradle Idler.
5.Attach the tension spring to the post on the Cradle Idler.
6.Position the Cradle Idler assembly in front of the hole in the leg assembly. Attach the wire connectors to the motor (red to the positive terminal, black to the negative terminal.)
7.Insert the Cradle Idler Assembly into the leg and secure with four screws.
Assembly\Disassembly
