Kodak 800 SERIES service manual Remove the E-Connect Network Assembly, To install the Top Cover

NovaJet 800 Series Service Manual

CAUTION

Applying too much torque to the lower screws can cause the mounts for the standoffs on the cover to break, requir- ing a replacement of the cover.

4.Secure the Right Cover with two screws located on the left side (torque to 15 in-lbs) and three located under the baseplate (torque to 8 in-lbs.)

To install the Top Cover:

1.Insert the pin located on the right side of the Top Cover into the corresponding hole on the Right Cover Assembly.

2.While depressing the retracting stop assembly on the left side of the Top Cover, lower the left side of the Top Cover into position and secure it to the Left Cover by releasing the retracting stop assembly.

Remove the E-Connect Network Assembly

CAUTION

Integrated circuits may beweakened or damaged by elec- trical discharge. Do not touch or work near integrated circuits without wearing an ESD wrist strap.

1.Disconnect the network cable and the small parallel cable from the back of the E-Connect Network Assembly.

2.Locate and remove the 4 screws securing the E-Connect Network Assembly to the bottom of the Platen. See Figure 5-3.

Assembly\Disassembly 5-6