Kodak 800 SERIES service manual Carriage Coupler Installation

NovaJet 800 Series Service Manual

Install the Carriage Assembly, Carriage Belt, and the Frame Tensioner

1.To install the Belt onto the right Carriage, the “bumps” on the belt (where the ends of the belt are joined together to make the belt continuous) must be positioned between the left and right posts of the Belt Clamp. See Figure 5-17.

2.Slide the Carriage Belt between the right post and the middle post and guide it down into the Belt Clamp. Then slide the Carriage Belt between the left post and the middle post and finish placing the Carriage Belt into the Belt Clamp.

3.Check the position of the Carriage Belt to make sure it matches Figure 5-17.

4.Make sure the left end of the Trailing Cables extends out beyond the left end of the Trailing Cable Support Assembly.

5.Position and hold into place the Carriage Coupler onto the right Carriage. See Figure 5-18.

Figure 5-18. Carriage Coupler Installation.

6.Slide the right Carriage onto the left end of the Slide Shaft, making sure that the Encoder Strip fits into the slot in the Slider and the

Assembly\Disassembly 5-28