Kodak 800 SERIES service manual

NovaJet 800 Series Service Manual

3.Remove the Service Station following procedures outlined earlier in this chapter.

CAUTION

Be careful when removing any foam blocks so that it does not tear. It is very important to have an intact foam block to produce sufficient vacuum inside the Platen. This is re- quired to properly hold the media down onto the Platen.

4.Using the access gained by removing the Right Sideplate and the Service Station, remove the right foam block from between the Lower Drive Roller Assembly and the Servo Motor.

5.Remove the Ink Delivery System following procedures outlined earlier in this chapter.

6.Remove the Left Assembly following procedures outlined earlier in this chapter.

NOTE

The 42 inch model has one Vacuum Fan and Exhaust as- sembly while the 60 inch model has two sets of Vacuum Fans and Exhausts.

7.Remove the four (eight) screws on the bottom of the Platen which hold the Fan Exhaust(s) in place.

8.While holding the Vacuum Fan through the hole where the Exhaust assembly was, remove the 3 screws on the bottom of the Platen that secure the Vacuum Fan(s) . Do not allow the screws to come out at an angle.

9.Remove the Platen Plug from under the Platen.

10.Remove the black flat-head screws from the top of the Platen that holds the Center Support in place. Remove the Center Support through the Platen Plug hole.

Assembly\Disassembly 5-49