Kodak 800 SERIES service manual Remove Memory Module, Memory Module Removal/Installation

NovaJet 800 Series Service Manual

4.Place the ESD Shield onto the Display standoffs using four kepnuts with a 1/4” socket or wrench. Torque to 2.5 in-lbs.

5.Attach ground connections to the Cover Standoffs as shown in Figure 5-5. Apply a small drop of loctite into the Cover holes, attach Standoffs and torque to 6 in-lbs.

6.Install the Top and Right Covers following procedures outlined earlier in this chapter.

Remove Memory Module

CAUTION

Integrated circuits may become weakened or damaged by electrical discharge. Do not touch or work near integrated circuits without wearing an ESD wrist strap.

1.Remove the Top and Right Covers following procedures outlined earlier in this chapter.

Figure 5-6. Memory Module Removal/Installation.

2.Facing the right side of the Memory Module, push the side clips gently to the outside (away from the memory module). Lift up and pull the module out. See Figure 5-6.

Assembly\Disassembly 5-10