NovaJet 800 Series Service Manual

4.Disconnect the grounding flex cable from the large standoff before removing the Keypad Assembly. See Figure 5-5 for location. Remove the Keypad Assembly.

Figure 5-5. Keypad and Display Grounding Connections.

Install the Keypad and Display

1.Route the Keypad flex data and ground cables into the Right Cover Assembly through the hole provided for the Keypad.

2.Place the Keypad into position and hold. Turn the Right Cover Assembly over and position the Display Assembly onto the threaded studs of the Keypad. Secure using four standoffs and washers. Tighten by hand.

3.Attach the Keypad grounding flex cable to the cover standoff as shown in Figure 5-5. Ribbon must be closer to the plastic side of the cover with the contact side towards the ground strap.

Assembly\Disassembly 5-9

Page 213
Image 213
Kodak 800 SERIES service manual Install the Keypad and Display, Keypad and Display Grounding Connections