Kodak 800 SERIES service manual

NovaJet 800 Series Service Manual

NOTE

The Paper Sensor and Encoder Sensor are only installed onto the right Carriage. All procedures in this section refer to the right Carriage only.

3.To remove the Paper Sensor:

a.Unlock the connector at J3 and remove the flex cable.

b.Turn the Carriage over and hold it while firmly grasping the Paper Sensor between thumb and index finger. See Figure 5-21.

c.Pull straight up on the Paper Sensor and remove it from the Carriage Assembly.

4.To remove the Encoder Sensor:

a.Unlock the connector at J2 and remove the flex cable.

b.Turn the Carriage over and lay it with the top side facing down.

c.Push down on the plastic clip and at the same time push down on the Encoder until the plastic pieces on each side of the Encoder clear the ridges which hold it in place. Then pull it straight out.

Assembly\Disassembly 5-35