Kodak 800 SERIES Replacing the Floating Carriage Cover Bushings, To install the Encoder Sensor

NovaJet 800 Series Service Manual

e.Turn the Carriage over and insert the Paper Sensor flex cable into the connector at J3.

f.Push both sides of the connector lock shut at the same time.

2.To install the Encoder Sensor:

a.Turn the Carriage so that the bottom side of it is facing up.

b.Push down on the plastic clip and slide the back of the Encoder Sensor over it.

c.Push the Encoder Sensor in past the ridges until the Encoder Sensor snaps into place.

d.Turn the Carriage over and insert the Encoder flex cable into the connector at J2.

e.Push both sides of the connector lock shut at the same time.

3.Install the Carriage Assembly and Ink Delivery System following procedures outlined earlier in this chapter.

4.Install the Top, Left and Right Covers following procedures outlined earlier in this chapter.

Replacing the Floating Carriage Cover Bushings

1.Position the Carriage Assembly to the right side of the center of the Slide Shaft. Make sure that the Chain Guide on the Chain Support Bracket is not blocking the Floating Carriage Cover or it may be very difficult to perform these procedures.

2.Remove the three screws securing the Left Support Bracket to the Floating Cover. Slide the Left Support Bracket to the left, away from the Carriage Assembly and Floating Carriage Cover.

NOTE

Only one Support Bracket needs to be removed from the Floating Carriage Cover for this procedure. In these pro- cedures the left one is being removed, but the right one can just as easily be taken off instead.

Assembly\Disassembly 5-37