NovaJet 800 Series Service Manual

NOTE

The right side fixed nylon helical wedge and pin assembly/flange should not have to be removed unless the screw length prohibits lower roller removal. Three 1/8” and 5/32” allen head screws are used to secure these assemblies).

To remove the stepper motor from lower roller remove the 2 securing screws, 2 nuts, and spring. Note the orientation of the motor with respect to the lower roller. For new motor installations verify support bracket to motor gap is .005” to .015” on the non-screwed side using a feeler gauge.

Lower Roller Installation Tip (NovaJet 880)

To install the lower roller/stepper motor assembly:

1.Place all assemblies on a flat surface. Ensure the vacuum fan openings are facing away from the stepper motor. Fan #1 should be between rollers 1 & 2 while fan #2 should be between rollers 3 & 4.

2.Install assemblies into printer together and lock vacuum fans in place first before attaching other assemblies.

NOTE

The thick arm of the center support bracket faces towards the front of the printer on reinstallation.

Y-Arm Assembly Installation Tip (NovaJet 880)

Before installing the Y-Arm assembly, loosely attach the right fixed- platen end screws – do not tighten.

NOTE

When installing the Y-Arm assembly alignment of the print head is referenced to the left fixed-platen end. Install Y-Arm by tightening the 4 screws on the left side first, followed by the right side screws. Ensure the cutter groove is straight across all three platen sections.

Assembly\Disassembly 5-57

Page 261
Image 261
Kodak 800 SERIES service manual Lower Roller Installation Tip NovaJet, Arm Assembly Installation Tip NovaJet