Kodak 800 SERIES To remove the Right Cover Assembly, Right Cover Assembly Removal/Installation

NovaJet 800 Series Service Manual

3.Lift up on the left side of the Top Cover until it clears the Left Cover while still depressing the retracting stop assembly, then slide the cover to the left to disengage it from the Right Cover.

To remove the Right Cover Assembly:

Figure 5-1. Right Cover Assembly Removal/Installation.

4.With a #2 Phillips screwdriver, remove the three screws securing the Right Cover Assembly to the Right Baseplate and the two screws securing it to the Right Sideplate. See Figure 5-1.

5.Reach under the Support Bracket and depress and hold the retracting stop assembly that secures the Right Cover Assembly to the Support Bracket.

6.Carefully lift up on the Right Cover Assembly until it clears the printer enough to gain access to the Keypad and Display connections going to the Main Printed Wiring Assembly (PWA).

7.Disconnect the Keypad flex cable connection at the J9 location on the Main PWA. See Figure 3-4 for jack locations on the Main PWA.

Assembly\Disassembly 5-3