26 en Installing a Surface Mount | AutoDome Easy II IP |
|
|
3.Drill the four (4) holes in the installation location. Use a minimum screw length of 10 mm (.39 in.).
4.Prepare the surface so that it can support a maximum load of 11.33 kg (25 lbs).
5.Thread the four (4) 3.97 mm I.D. by Ø1.78 mm
6.Ensure that the gasket is attached to the retaining ring. If the gasket and the retaining ring are separate:
a.Locate the flat side of the gasket and the recessed side of the retaining ring.
b.Thread the flat side of the gasket (item 1, below) onto the recessed side of the retaining ring (item 2). The illustration below shows a
CAUTION!
You must ensure that the gasket is attached to the retaining ring as shown above to ensure an environmentally tight seal.
F.01U.164.576 2.0 2010.03 | Installation Manual | Bosch Security Systems, Inc. |