Bosch Appliances VEZ installation manual Installing a Surface Mount, Description

22 en Installing a Surface Mount AutoDome Easy II IP

4Installing a Surface Mount

4.1Description

This chapter details how to mount the AutoDome Easy II to a hard surface. The AutoDome Easy II is also suitable for wall (Section 5 Installing a Wall Mount, page 33), recess (Section 6 Installing a Recessed Mount, page 44), and pipe mounting (Section 7 Installing a Pipe Mount, page 52). For specific directions on mounting the unit, see the manual that came with your mount.

For an outdoor installation you must obtain the Surface Mount Junction Box (VEZ-A2-JC or VEZ-A2-JW) and the gaskets and O- rings supplied with an AutoDome Easy II Outdoor Camera to ensure a water-tight environment inside the unit and to maintain an IP Environmental Protection Rating. Refer to Section 4.1.3 Preparing the Surface Mount for an Outdoor Installation, page 25, to start an outdoor installation.

NOTICE!

The image sensors in modern CCD cameras are highly sensitive and require special care for proper performance and extended lifetime. Follow the guidelines for optimum results with your camera:

–Do not expose to direct sunlight or bright spotlights in

operating and nonoperating conditions.

–Avoid bright lights in the field of view of the camera. Bright lights cause a “smearing” effect, which is visible as white lines above and below the highlight. Prolonged exposure to bright lights may cause bleaching of the sensor's color filters. This will be visible as colored spots in the picture and is irreversible.

F.01U.164.576 2.0 2010.03 Installation Manual Bosch Security Systems, Inc.