48 en Installing a Recessed Mount | AutoDome Easy II IP |
|
|
NOTICE!
Over torquing the ceiling clamps can damage the clamp or ceiling. Only tighten the clamp until it contacts the ceiling and you start to feel some resistance. If using a power screwdriver, set the torque level to the lowest setting.
6.1.3Installing the Camera to the Mounting Plate
To install the base to a surface or suspended ceiling using the supplied mounting plate, do the following:
1.Use supplied
2.
3.Route wires on side of mounting plate with crescent shaped
CAUTION!
All wires for installation applications must be routed through a grounded conduit.
4.Attach grounding wire from unit to the mounting bracket.
5.Attach user supplied ground to junction box.
6.Connect the mating connectors with the flying leads to the user supplied wiring (see the Section 8 Preparing the Wiring, page 63 for wiring information).
7.Remove the single safety locking screw on the base of the unit using the
Figure 6.5 Unlock Safety Locking Screw
F.01U.164.576 2.0 2010.03 | Installation Manual | Bosch Security Systems, Inc. |