128 en Troubleshooting | AutoDome Easy II IP |
|
|
17 Troubleshooting
If you experience difficulties operating your AutoDome Easy II camera, refer to the following. If the guidelines do not enable you to solve the problem, contact an authorized technician.
Problem | Check |
|
|
Need to remove trim | Use a slotted screw driver and push the clips |
ring. | outward while gently pulling down on the edge of |
| the trim ring. |
|
|
Nothing appears on | Are the power cord and line connection between |
the screen. | the camera and monitor made properly? |
|
|
The image on the | Is the lens dirty? If so, clean the lens with a soft, |
screen is dim. | clean cloth. |
|
|
The contrast on the | Adjust the contrast feature of the monitor. Is the |
screen is too weak. | camera exposed to strong light? If so, change the |
| camera position. |
|
|
The image on the | Does the camera face directly into the sun or |
screen is flickers. | fluorescent lighting? If so, reposition camera. |
|
|
The image on the | Is the power frequency set properly in sync? If the |
screen is distorted. | power frequency is not set correctly, the line lock |
| synchronization mode cannot be used. Set the |
| synchronization mode to INT.NTSC Model power |
| frequency in LL mode: 60 Hz. |
|
|
F.01U.164.576 2.0 2010.03 | Installation Manual | Bosch Security Systems, Inc. |