AutoDome Easy II IP Installing a Recessed Mount | en 51
Bosch Security Systems, Inc. Installation Manual F.01U.164.576 | 2.0 | 2010.03
12. Ensure unit is centered.
Figure 6.9 Align Trim Ring
13. Align trim ring so screws align with off center holes.
Note: The two (2) sets of raised stand-offs on each side of
the trim ring align with the locking clamps.
14. Use supplied T-10 wrench to secure the trim ring’s two (2)
safety locking screws to the mounting bracket.
15. Snap trim ring into place. Ensure snaps are secure by
attempting to lightly turn unit. Note: Unit should not turn.
NOTICE!
The recessed mounting bracket is provided with a an additional
safety tether point. To prevent injury, attach a safety wire from
a secure anchor point above the ceiling to this tether point.
1Clamp
2 Stand-offs
3Trim Ring