Kodak 800 SERIES service manual Install the Carriage PWA

NovaJet 800 Series Service Manual

5.Unlock the latch on the right end of the Carriage and lift up the right end of the Carriage PWA. See Figure 5-20.

6.Slide the Carriage PWA to the right to remove the tab on the left end of the Carriage PWA from the slot in the Carriage.

CAUTION

Failure to use an approved antistatic bag for storage or shipment may cause damage to the Carriage PCB and affect the Warranty.

7.Place the Carriage PWA in an ESD bag (antistatic bag) in preparation for shipment to ENCAD for replacement or repair, or if it is to be stored at your facility for repair.

Install the Carriage PWA

1.Put the tab on the left end of the Carriage PWA into the slot in the left side of the Carriage. See Figure 5-20.

2.Ensure that no flex cables are underneath the Carriage PWA.

3.Push down the right end of the Carriage PWA until the latch snaps into place.

4.Reattach all flex cables on the Carriage PWA.

5.Install the Carriage Assembly and Ink Delivery System following procedures outlined earlier in this chapter.

6.Install the Top, Left and Right Covers following procedures outlined earlier in this chapter.

Assembly\Disassembly 5-33