AMX CV7 Install the new Compact Flash Memory card NXD, Close and Resecure the NXD Panel Enclosure

CV7 Touch Panel Accessories

Caution: Speaker wires come connected to this side of the main board. Use caution when removing the back box.

Connector Overlay must first be removed from the side of the NXD

Wireless CF card (Slot #2 is located on the top slot)

FIG. 23 Location of the wireless CF card connector on main board

The circuit board comes pre-wired to internal speakers located on the inside surface of the rear back box. If the back box is removed incorrectly, these speaker wires can become disconnected and damaged.

6.Carefully lift-off the back box housing and angle it over to the side of the unit where the wires are connected to the circuit board.

7.Gently lay the back box to one side of the unit. This exposes the internal circuit board (FIG. 23). Take care not to place undue strain on the speaker cables.

Step 2: Install the new Compact Flash Memory card (NXD)

1.Complete the procedures outline within Step 2: Install the Compact Flash Memory card upgrade section on page 21 and then continue with the following Step 3.

Step 3: Install the new 802.11g Wireless Compact Flash card (NXD)

1.Complete the procedures outline within Step 3: Install the new 802.11g CF Card and Antenna section on page 22 and then continue with the following Step 4.

Step 4: Close and Resecure the NXD Panel Enclosure

1.Gently place the outer housing back onto the panel and align the four pan-head Housing Screws holes along the edges of the outer housing.

2.Insert and secure the four pan-head Housing Screws back into their pre-drilled holes by using a grounded Phillips-head screwdriver.

3.Slip the connector overlay back into the connector opening by inserting the top of the overlay into the connector opening in an upwards direction.

4.Align the connectors to their respective locations and secure the overlay by pushing it towards the connectors until the overlay securely snaps back into the overlay release latches.

5.Re-install the faceplate back onto the panel. Refer to the Installing the Button Trim Ring section on page 35 for more detailed faceplate installation information.

7" Modero Widescreen Touch Panels 25