AMX CV7 manual Light Sensor, Light Level field, Dim Mode Minimum, Motion Sensor

Firmware Pages and Descriptions

Sensor Setup Page Elements (Cont.)

Light Sensor:	Allows you to monitor and alter the sensitivity of the Modero panel light sensor:
	• The Light Sensor Level field indicates the level used to report the light
	sensor level back to the NetLinx Master (set in TPD4) (read-only).
	• The Light Sensor Level Port field indicates the port used to report the light
	sensor level back to the NetLinx Master (set in TPD4) (read-only).
	• The Light Sensor Channel field indicates the level used to report the sensor
	channel back to the NetLinx Master (set in TPD4). It is On when you are
	below the Maximum dim mode level (read-only).
	• The Light Sensor Channel Port field indicates the port used to report the
	sensor channel back to the NetLinx Master (set in TPD4) (read-only).
	• The Light Level field provides a numeric value representing the current value
	of the light level detected by the on-board photo-sensor.
	• The Light Level bargraph displays a horizontal bargraph indicating the current
	value of the light level detected by the on-board photo-sensor. This bargraph
	provides a visual representation of the numeric value displayed within the
	Light Level field.
	• Use the Dim Mode Max Level bargraph to alter the Maximum DIM level
	value used to activate the DIM Mode Brightness Level (range = 0 - 100).
	• Use the Dim Mode Min Level bargraph to alter the Minimum DIM level value
	used to activate the DIM Mode Brightness Level (range = 0 - 100).
	- The position of this bargraph can never exceed that of the Dim Mode
	Max Level.
Dim Mode Minimum	Allows you to alter the sensitivity of the Modero panel light sensor:
Brightness:	• Toggle the Enable/Enabled button to either active/inactive the DIM Mode
	feature:
	- Enable - activates this feature. Once active (by receiving a value below the
	Dim Mode Min Level value), the current light level ramps to the DIM Mode
	value within a few seconds.
	- Enabled - (illuminated when selected) deactivates this feature.
	• Use the DIM Mode Brightness UP/DN buttons to alter the DIM level.
	- Range = 0 - 100.
	- The lower the value, the darker a room must be before the LCD Brightness
	value changes to conform to a DIM room (and vice versa with a higher
	value).
	• The DIM Mode Minimum Brightness bargraph indicates the current DIM
	Mode Brightness level.
	- This level corresponds to the brightness level of the LCD used when
	the DIM Mode is active.
	- The Brightness value of the panel in a DIM room (low-light) is much
	less than that of a Non-DIM (well to brightly-lit) where the LCD Brightness
	must be higher to display the screen content clearly.
Motion Sensor:	Provides the following fields:
	• The Motion Detection field displays a reactive button that changes color
	(illuminates) and displays the words "Motion Detected" when motion is
	detected by the Modero panel’s front motion sensor.
	• The Motion Sensor Port field indicates the port used to report the motion
	sensor channel back to the NetLinx Master (set in TPD4) (read-only).
	• The Motion Sensor Channel field indicates the channel used to report the
	motion sensor channel back to the NetLinx Master (set in TPD4) (read-only).

106 7" Modero Widescreen Touch Panels