AMX CV7 manual Panel Calibration

Table of Contents
Recalibrating the batteries	32
Installation	33
Unpacking the Panel	33
Installing the Internal Components	33
Installing the No-Button Trim Ring	33
Installing the Button Trim Ring	35
Pre-Wall Installation of the Rough-In Box	36
Installation of an NXD Touch Panel	37
Installing the NXD panel within a Rough-In Box	37
Installing the NXD into drywall using Expansion Clips	39
Installing the NXD into a Flat Surface using #4 screws	42
Installing an NXD-CV7 into an (optional) Rack Mount Kit (NXA-RK7)	44
Wiring Guidelines for the CV7 Panels	45
Preparing captive wires	45
Wiring a power connection	45
Audio/Video Port: Connections and Wiring	46
Ethernet/RJ-45 Port: Connections and Wiring	46
USB Port: Connecting and Using Input Devices	47
Panel Calibration	49
Calibrating the Modero Panel	49
Testing your Calibration	50
Configuring Communication	51
Modero Setup and System Connection	51
Configuring and Using USB with a Virtual Master	53
Step 1: Setup the Panel and PC for USB Communication	53
Step 2: Confirm the Installation of the USB Driver on the PC	53
Step 3: Confirm and View the current AMX USB device connections	55
Step 4: Use the USB to Configure a Virtual Master (using NetLinx Studio)	56
Step 5: Confirm and View the current AMX USB device connections	58
Wireless Settings Page - Wireless Access Overview	58
IP Routing	58
Hot Swapping	59
Configuring a Wireless Connection	59
Step 1: Configure the Panel’s Wireless IP Settings	60
Wireless communication using a DHCP Address	60
Wireless communication using a Static IP Address	61
Using the Site Survey tool	61
Step 2: Configure the Card’s Wireless Security Settings	63
Configuring the Modero’s wireless card for unsecured access to a WAP200G	63

ii 7" Modero Widescreen Touch Panels