CV7 Touch Panel Accessories

Battery Life (Charge) Display

Battery Life Indicator button

FIG. 26 NXT-BP Battery Pack (showing the battery life indicator and button)

It is recommended to fully charge this battery before using it to power an NXT-CV7 panel. If the 25% LED indicator is blinking, recharge your battery immediately. This blinking indicates there is less than 5% of a charge remaining on the battery.

Installing an NXT-BP into the NXA-BASE/1

The base does not directly connect to a power supply. Instead, it receives the power necessary to charge the battery from the Modero panel (through the Panel Interface connector).

1.Install the NXT-BP battery into the base’s battery compartment with the label-side facing up.

2.Align the battery connector with its corresponding battery connector port (located in the battery compartment shown in FIG. 27).

NXT-BP Battery

Battery

Connector

Battery

Connector

Port

FRONT

FIG. 27 Battery installation

3.Carefully insert the NXT-BP into the base until the battery securely fits onto the Battery Connector Port.

Installing the NXA-BASE/1 below an NXT-CV7 Panel

1.Power Off the panel before attempting to attach the NXA-BASE/1.

2.Place the battery base (with battery) onto a flat/level surface.

3.Turn the battery locking slider (FIG. 28) to one side until the locking mechanism is horizontal to the base (going left to right) and the rear battery latch is pointing directly outward (away from the LCD).

28

7" Modero Widescreen Touch Panels

Page 37 Page 39
Page 38
Image 38
AMX manual Installing an NXT-BP into the NXA-BASE/1, Installing the NXA-BASE/1 below an NXT-CV7 Panel, Front
Page 37 Page 39
Top Page Image Contents