Installation

1.Remove the Faceplate/bezel (A in FIG. 37) from the main NXD unit (B in FIG. 37) by gripping the faceplate and pulling with gentle outward force.

C - Optional CB-TP7

rough-in/wallbox

#4-40 Mounting Screws

(four - included)

secure the NXD to

the Rough-In Box

Stud

Mounting Tab

B - Main NXD unit consists of

the touch panel and back box housing

A - Faceplate/Trim Ring

default Faceplate comes with buttons

FIG. 37 NXD-CV7 panel installation into a CB-TP7 (pre-wall construction)

2.Verify the incoming power, RJ-45 audio/video, Ethernet, and USB cables have been properly threaded through the wiring knockouts on the left of the rough-in box. Leave enough slack in the wiring to accommodate any re-positioning of the panel.

3.Connect all data and power wiring connectors to their corresponding locations along the side of the (un-powered) NXD touch panel.

Verify that the terminal end of the power cable is not connected to a power source before plugging in the 2-pin power connector.

The USB connectors can be from either a USB extension cable, or a wireless USB RF transmitter.

4.Test the incoming wiring by connecting the panel connections to their terminal locations and applying power. Verify that the panel is receiving power and functioning properly to prevent repetition of the installation.

5.Disconnect the terminal end of the power cable from the connected power supply.

Don’t disconnect the connectors from the touch panel. The unit must be installed with the attached connectors before being inserted into the rough-in box.

6.Carefully slide the main NXD-CV7 unit (B in FIG. 37) into the rough-in box, so that all Mounting Tabs lie flush against the rough-in box (C in FIG. 37).

7.Insert and secure four #4-40 Mounting Screws (included) into their corresponding holes located along the sides of the NXD.

38

7" Modero Widescreen Touch Panels

Page 48
Image 48
AMX CV7 manual Faceplate/Trim Ring Default Faceplate comes with buttons