
Installation
11.Reconnect the terminal
12.Reconnect the terminal power connector on the 12
Installing an
The
1.Remove the Faceplate/Trim Ring assembly from the main CV7 unit.
2.Thread the incoming power,
3.Connect all data and power wiring connectors to their corresponding locations along the left side of the
Verify that the terminal end of the power cable is not connected to the a power supply before plugging in the
The USB connectors can be from a either a USB extension cable, or a wireless USB RF transmitter.
4.Test the incoming wiring by connecting the panel connections to their terminal locations and applying power. Verify that the panel is receiving power and functioning properly to prevent repetition of the installation.
5.Disconnect the terminal end of the power cable from the connected power supply.
Don’t disconnect the connectors from the touch panel. The unit must be installed with the necessary connectors before being inserted into the equipment rack.
6.Carefully insert the CV7 panel into the
7.Secure the panel to the
8.Insert the
9.Use a grounded
10.Place the Faceplate/Trim Ring assembly back onto the main NXD unit. Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective openings on the front faceplate/bezel.
11.Reconnect the terminal
12.Reconnect the terminal power connector on the 12
44 | 7" Modero Widescreen Touch Panels |