CV7 Touch Panel Accessories
87" Modero Widescreen Touch Panels
Installing the NXA-AVB/ETHERNET

A 12 VDC-compliant power supply can indirectly provide power to a Modero panel by routing power

through the NXA-AVB/ETHERNET Breakout Box. FIG.5 shows a sample wiring configuration using

both an indirect or direct power connection for a video-capable Modero panel.

A 12 VDC-compliant power supply can also directly provide power through the unit to a target Modero

panel. FIG. 6 shows a sample wiring configuration for a non-vide o capable Modero panel.
NXA-AVB/ETHERNET Specifications (Cont.)
Rear Components: • 6-pin 3.5 mm Phoenix connector for in-bound (left/right channel) audio
• 4-pin 3.5 mm Phoenix connector for out-bound (from microphone) audio
• BNC connector (female) for Composite or Chroma (for video-capable
panels only)
• BNC connector (female) for luminance (for video-capable panels only)
• RJ-45 connector for Ethernet input from the control system
• 2-pin 3.5 mm Phoenix connector for in-bound power
Included Accessories: • Two 2-pin Phoenix connectors (41-5025)
• 4-pin Phoenix connector (41-5047)
• 6-pin Phoenix connector (41-5063)
• Rack Mount Kit (KA2250-40) with mounting bracket (62-2254-02)
Other AMX Equipment: •AC-RK Accessory RackMount Kit (FG515)
• Modero Table Top Cable (CA2250-50)
FIG. 5 Sample wiring configuration on video-capable panels using this breakout box
FIG. 6 Sample wiring configuration using non-video capable Modero panels

NXD/T Video-capable

Ethernet In
12 VDC power
(RJ-45)

Video In

(BNC)

Mic Out
(4-pin captive-wire)
Audio In
(6-pin captive-wire)

NXA-AVB/ETHERNET

Power
supplied via
NXA-AVB box
Audio/Video
(CAT5)
Line Level out
(to amplifier
or VOL card)

Touch Panels

or

Direct
Connect

Breakout Box

Ethernet
(rear)
(front)
(CAT5)
supply
Indirect
Connect
12 VDC power
supply
Direct
connect

NXD/T Non-video capable

Ethernet
(CAT5)

Touch Panels

12 VDC power
Audio (CAT5)
between the
NXA-AVB/ETHERNET
Breakout Box
supply