AMX CV7 manual Back

CV7 Touch Panel Accessories

Alignment	Back	Battery
pegs (2)		locking
Panel Interface		mechanism
connector (male)

Battery locking slider

(Battery not shown

for illustration purposes)

Front

Insert holes for

NXT-CV7 feet

Securing pegs (2)

FIG. 28 NXA-BASE/1 showing Panel Interface and connector locations

4.Carefully angle the NXT-CV7 panel over the front alignment pegs (FIG. 29). The pegs assist in both aligning and securing the panel to the base (the locking mechanism secures the base to panel when done).

	Battery
	locking
	mechanism
Alignment	(with locking
	slider)
pegs

FIG. 29 NXA-BASE/1 shown aligning with NXT-CV7 panel

5.Insert the alignment pegs into their corresponding holes below the front of the panel.

6.Verify the alignment of the Panel Interface connectors between the panel (female connector) and base (male connector) (FIG. 29).

7.Align the rear pegs and gently push the rear of the panel downwards until it is mounted atop the battery base.

The battery base CANNOT be hot-swapped. An NXT can not be receiving power (through a connected power supply) and then be connected to a battery base. Always POWER OFF the panel before installing the NXA-BASE/1.

8.Slide the rear battery locking slider in the opposite direction. This turns the latching mechanism and secures the panel to the base.

9.Upon successful connection, the AMX logo appears on the panel to indicate that the panel is properly connected and receiving power.

7" Modero Widescreen Touch Panels 29