Installation

CV7 Panel/enclosure

Button latch

Trim

Ring

Latches

Light Pipe latch (black)

Button and Light Pipe removal

(showing the internal surface of Faceplate)

Default Button Trim Ring (with button openings)

Faceplate (outside surface shown)

FIG. 32 Removing the default Button Trim Ring

6.Remove the pair of clear light pipe strips by bending the two black light pipe latches inwards and pulling out the strip.

7.Grasp the No-Button Trim Ring on both sides and fit it into the groove along the outside surface of the Faceplate (made available by the removal of the previous Trim Ring).

8.Gently insert the Trim Ring latches into their corresponding openings on the outer surface of the internal Faceplate (FIG. 33).

No-Button Trim Ring

Hollow button openings

Faceplate (outer surface shown)

FIG. 33 Inserting the No-Button Trim Ring

9.Firmly press down around the No-Button Trim Ring until all of the latches are securely inserted into their openings on the Faceplate, and the No-Button Trim Ring is securely fastened. Verify the No-Button Trim Ring is firmly inserted onto the Faceplate and that there are no gaps between this Trim Ring and the outer surface of the Faceplate.

34

7" Modero Widescreen Touch Panels

Page 44
Image 44
AMX manual CV7 Panel/enclosure Button latch Trim Ring