CV7 Touch Panel Accessories

Card removal grooves

On-board Compact

Flash connector (with pins)

Insert with arrow facing towards the pins

Connector opening

FIG. 20 Removing/installing a Compact Flash Memory card

Any new internal card upgrade is detected by the panel only after power is cycled.

Step 3: Install the new 802.11g CF Card and Antenna

1.Discharge any static electricity from your body by touching a grounded metal object and then locate the wireless card slot on the main board (FIG. 21).

2.Insert the tip of a grounded flat-head screwdriver into one of the card removal grooves (located on either side of the existing card), and gently pry the card out of the slot (FIG. 21). Repeat this process on the opposite card removal groove. This alternating action causes the card to "wiggle" away from the on-board connector pins.

3.Grip the old card by its sides and then carefully pull it out of the slot.

4.Remove one of the included alcohol pads and use it to thoroughly clean both the CF metal cover (FIG. 21) and the metal plate on the underside of the terminal antenna. These surfaces must be properly cleaned to provide good adhesion for the later installation of the wireless antenna.

Tilt Bracket cover plate

Front of panel

Wireless CF Card (Slot 2)

Compact Flash

Memory Card (Slot 1)

CF metal plate (with antenna shown installed)

Card Removal

Grooves

FIG. 21 Location and orientation of the card slots (both CV7/CV10 panels)

5.Remove the new NXA-WC80211G CF card from it’s anti-static bag.

6.Grip the sides of the new wireless card and insert it firmly into the slot opening until the contact pins are completely inside the card and securely attached to the pin sockets.

22

7" Modero Widescreen Touch Panels

Page 32
Image 32
AMX CV7 manual Install the new 802.11g CF Card and Antenna, Removing/installing a Compact Flash Memory card