Configuring Communication

One of the most common problems associated with connection to a WAP arise because the SSID was not entered properly. You must maintain the same case when entering the SSID information. ABC is not the same as Abc.

10.Click Done when you’ve completed typing in the information.

11.From the Open (Clear Text) Settings page (FIG. 62), press the Save button to incorporate your new information into the panel and begin the communication process.

12.Verify the fields in the IP Settings section have been properly configured. Refer to Step 1: Configure the Panel’s Wireless IP Settings section on page 60 for detailed information.

13.Press the Back button to return to the Protected Setup page and press the on-screen Reboot button to both save any changes and restart the panel. Remember that you will need to navigate to the

System Settings page and configure the connection to a target Master.

14.After the panel restarts, return to the Wireless Settings page’s RF Link Info section and verify the Link Quality and Signal Strength:

The descriptions are: None, Poor, Fair, Good, Very Good, and Excellent (FIG. 62).

The signal strength field should provide some descriptive text regarding the strength of the connection to a Wireless Access Point. If there is no signal or no IP Address displayed; configuration of your network could be required.

Configuring the Modero’s wireless card for secured access to a WAP200G

After logging into the WAP200G, the default Status page appears within the web browser. These read-only values are "pulled" from some of the other user-configurable Configuration Utility pages. By default, wireless Modero panels are configured for unsecured communication to a Wireless Access Point. To properly setup both the WAP200G and panel for secure communication, you must first prepare the Modero panel and then use the information provided to fill out the fields within the WAP’s browser-based Basic Wireless Configuration page.

Since the code key generator on Modero panels use the same key generation formula, all panels will generate identical keys for the same Passphrase. The generators used on WAPs will not produce the same key as the Modero generator even if you use the same Passphrase. For this reason, we recommend

FIRST creating the Current Key on the Modero and then entering that information into the appropriate NXA-WAP200G fields.

1.Provide power to the panel (this allows it to detect the internal wireless card).

2.Press the Protected Setup button (located on the lower-left of the panel page) to open the Protected Setup page and display an on-screen keypad.

3.Enter 1988 into the Keypad’s password field and press Done when finished.

4.Press the Wireless Settings button (located on the lower-left) to open the Wireless Settings page.

5.Locate the Wireless Security section (FIG. 63).

7" Modero Widescreen Touch Panels

65

 

 

Page 75
Image 75
AMX CV7 manual Configuring Communication