AMX CV7 manual Do not Remove these screws

CV7 Touch Panel Accessories

Unscrew these four Housing Screws to remove the Circuit Board Cover

Base

Hinge Brackets (2)

Touch Panel

DO NOT REMOVE these screws

They secure the plastic base front cover.

FIG. 16 Location of the attachment screws underneath an NXT-CV7 panel base

Note the location of the four plastic adhesive "feet". Once the outer housing is placed back onto the panel, these "feet" must be placed back onto their original locations so they can fit into their provided openings on a Battery Base.

4.Rotate the panel back over (while gripping the entire unit and outer housing) and rest the base back onto a flat surface.

5.Gently tilt the LCD panel backwards to expose the Tilt Bracket/Speaker assembly (FIG. 19).

	Tilt Bracket/Speaker assembly
	Tilt Bracket Screws (2)
Outer Housing	These two screws must
	first be removed before
	being able to remove
	the outer housing.
	Base

Hinge Brackets (2)

FIG. 17 Location of the Tilt Bracket screws

6.Locate the two screw holes at either sides of the front speaker grill and then use a grounded Phillips-head screwdriver to remove the two Tilt Bracket Screws (FIG. 17). This procedure both loosens the rear Tilt Bracket cover plate (with the AMX logo and Hinge brackets) and provides greater flexibility for the removal of the outer housing. Without this step, the Hinge brackets (FIG. 17) present an obstacle to the removal of the outer housing and restrict access to the circuit board.

7.Tilt the LCD panel back up to gain better access to the Tilt Bracket cover plate.

8.In a single motion, carefully pull both the Tilt Bracket cover plate and outer housing up and then out (away from the LCD panel) to expose the internal circuit board (FIG. 18).

20 7" Modero Widescreen Touch Panels