AMX CV7 manual Configure the Card’s Wireless Security Settings

Configuring Communication

In an Open security mode, when a target WAP is selected and the connect to, the SSID name of the selected WAP is saved for the open security mode.

In a Static WEP security mode, when a WEP Access Point is selected and then connected to, the user is then redirected back to the Static WEP security screen where the SSID field is already filled out and the user is only required to enter in the remaining WEP key settings.

A similar process occurs for WPA-PSK access points. For any other case, the firmware switches back to the previous page and security and connection parameters must be entered in as normal.

Step 2: Configure the Card’s Wireless Security Settings

The second step to successfully setting up your wireless card is to configure the Wireless Settings section of the Wireless Settings page. The section configures both the communication and security parameters from the internal wireless card to the WAP. The procedures outlined within the following sections use

an 802.11g card to configure a common security configuration to a target WAP.

Once you have completed setting up the wireless card parameters, you must then navigate to the System Settings page and configure the communication parameters for the target Master. Until those parameters are configured, your Connection Status icon will remain red (indicating that there is no current connection to a Master).

Configuring the Modero’s wireless card for unsecured access to a WAP200G

Prior to beginning the configuration of the wireless settings, verify that the panel has been upgraded to a wireless panel via the installation of the NXA-WC80211GCF wireless CF card.

1.Power-down the panel and follow the wireless card installation procedures outlined in the Installation and Upgrade of the Internal NXT Components section on page 19 and Installation and Upgrade of the Internal NXD Components section on page 24.

2.Power-up the panel (this allows it to detect the card).

3.Press the Protected Setup button (located on the lower-left of the panel page) to open the Protected Setup page and display an on-screen keypad.

4.Enter 1988 into the Keypad’s password field and press Done when finished.

5.Press the Wireless Settings button (located on the lower-left) to open the Wireless Settings page.

MVP connection IP info.

Wireless

card security settings

FIG. 60 Wireless Settings page (showing a sample unsecured configuration)

7" Modero Widescreen Touch Panels 63