AMX CV7 manual Install the Compact Flash Memory card upgrade

CV7 Touch Panel Accessories

Outer Housing

Tilt Bracket cover plate (must be removed first)

Outer housing installation holes (located on front panel)

Base

FIG. 18 Removal of the outer housing and wireless card location

Step 2: Install the Compact Flash Memory card upgrade

1.Discharge any static electricity from your body by touching a grounded metal object and then locate the existing 64 MB Compact Flash card on the main board (FIG. 19).

Front of panel

Tilt Bracket cover plate

Compact Flash	Wireless CF Card
Memory Card (Slot 1)	(Slot 2)
Card Removal Grooves	Card removal grooves

FIG. 19 Location and orientation of the card slots (both CV7 panels)

2.Insert the tip of a grounded flat-head screwdriver into one of the card removal grooves (located on either side of the existing card), and gently pry the card out of the slot (FIG. 20). Repeat this process on the opposite card removal groove. This alternating action causes the card to "wiggle" away from the on-board connector pins.

3.Grip the old card by its sides and then carefully pull it out of the slot.

4.Remove the new CF memory card from it’s anti-static bag.

5.Grip the sides of the new CF memory card and firmly insert it into slot opening (with the arrow facing towards the pins) until the contact pins are completely inside the flash card and it is then securely attached to the pin sockets.

6.To complete the upgrade process, either upgrade the remaining wireless card (Step 3) or close and re-secure the enclosure using the procedures in Step 4: Close and Resecure the NXT Panel Enclosure section on page 23.

7" Modero Widescreen Touch Panels 21