CLEARANCES
When facing the front of the appliance the following minimum clearances to combustible construction must be maintained. Do not install in alcove or closet.
| ||
Left side | 5" (127mm) | 8" (203mm) |
Right side | 5" (127mm) | 8" (203mm) |
Rear wall | 0" (0mm) | 0" (0mm) |
Ceiling | 36" (914mm) | 36" (914mm) |
Minimum vertical clearance from a projections above | 36" (914mm) | 36" (914mm) |
the appliance (shelves, window sills, etc.) |
|
|
Floor (top surface of carpeting, tile, etc.) | 2" (51mm) | 2" (51mm) |
Provide adequate clearances around air openings.
Adequate accessibility clearances for purposes of servicing and proper operation must be provided.
|
|
Figure 3 | Figure 4 |
OPTIONAL FLOOR STAND INSTALLATION
SRS-18* and SRS-30 Floor Stand Installation
1.Align clearance holes on floor stand with screw holes on bottom of heater, as shown in Figure 5.
2.Attach floor stand to heater with (4) screws provided with floor stand.
3.Connect the gas line.
*
Installation on Rugs and Tile
If this appliance is installed directly on carpeting, tile or other combustible material, other than wood flooring, the appliance shall be installed on a metal or wood panel extending the full width and depth of the appliance.
Attention: Optional
The base referred to in this section does not mean the
base as used on wood stoves. The protection | is for rugs that are |
extremely thick and light colored tile. | Figure 5 |
Page 8 |