Samsung SSA-P102T user manual Communication Line Connection, RS-232 Communication Port Connection

Page 15

COMMUNICATION LINE CONNECTION

RS-232 Communication Port Connection

A 9-pin connector for serial communication is required to make connection to the PC.

Connect the 9 pin connector for RS-232 communications as follows:

HOST PC

RS-232

9-Pin Female Connector

1.Connect RS-232-TX to pin #2 of the 9-pin connector.

2.Connect RS-232-TX to pin #3 of the 9-pin connector.

3.Connect RS-232-GND to pin #5 of the 9-pin connector.

4.Connect the serial communication connector to the serial COM port of the computer.

5.Install and launch the application (SAMS).

GND

- Check the location of the communication port.

INSTALLATION AND EXTERNAL CONNECTION

English _ 15

Image 15

Contents Please visit our website Access Control PanelSafety information Safety informationThis device may not cause harmful interference, Important Safety InstructionsContents Product introduction FeaturesWHAT’S Included Door Open Alarm and Forced Door Open AlarmHoliday Setup Duress ModeMain Board Input #2 Buzzer control settingsPower LED Displays the status of the power supply Input #3Cable Selection Termination Resistor in RS-422 Communication Connecting the Termination Resistor and DiodeTermination Resistor Bypass Diode ConnectionHost PC EARTH-GROUNDING the Communication CablesReader Connection POWER, READER, and I/O ConnectionPower Connection Check the location of the power portInput Connection Output Connection Check the location of the communication port RS-232 Pin Female ConnectorCommunication Line Connection RS-232 Communication Port ConnectionRS-422 Communication Port Connection Standalone RS-232CMAX m SSA-P102 RS-422 Communication Port Connection Multiple UnitsTCP/IP Communication Connection TCP/IP Communication Port ConnectionInitialization Reader Input BIT SetupInitializing the system using the Initialize switch Use the switch to set the valueBoard ID Setting Communication Speed SetupUse the switch to set the value Troubleshooting TroubleshootingProblem Action System is in sync with the PC Service for your helpIrrelevant card number is displayed Properly established D0, D1Product speciﬁcations Product SpecificationsCorrect disposal of batteries in this product