Samsung SSA-P102T user manual Main Board

Page 7

Main Board

2	3	4	5	6
1				14
				14
13
30
7				20
8				21
				21
9				22
				22

10
11			23
11
12			24
			24
			17
15			25
			25
18
			26
16
19	27	28	29

	1	Fixing Hole	Used to attach SSA-P102 to the closure using a metal supporter. (Ensure that you use
	1	Fixing Hole	the metal supporter to prevent the EMI.)
			the metal supporter to prevent the EMI.)
	2	2Pin DIP Switch	Used to set the type of a connected reader to either 26bit Wiegand or 34bit Wiegand.

			The device address and communication speed speciﬁed by the applicable switch should
	3	8Pin DIP Switch	be consistent with those of the computer that is used for communications.
	3	8Pin DIP Switch	(Address Setting: Pin 1 to Pin 5 of the DIP Switch, Communication Speed: Pin 6 to Pin 8

of the DIP Switch)

Pressing both of the switches at the same time for about 2 seconds will sound

4System Initialize Switch initialization ready beep. Releasing both switches will stop the beep, and restarts the system after the initialization.

	5	RJ-45	Connect the LAN cable for TCP/IP communications.
	6	LED	Indicates the state of the LAN communications.

	7	RL#1, RL#2	Ports where the buzzer control line or the LED control line of the reader is connected to
	7	RL#1, RL#2	display the operation status of Relay 1 or Relay 2.
			display the operation status of Relay 1 or Relay 2.
	8	Input #5	Input Port: The ﬂashing LED indicator denotes that a signal is sensed by the port.

	9	Input #4	Input Port: The ﬂashing LED indicator denotes that a signal is sensed by the port.

PRODUCT INTRODUCTION

English _ 7

Image 7

Contents Please visit our website Access Control PanelSafety information Safety informationThis device may not cause harmful interference, Important Safety InstructionsContents Product introduction FeaturesWHAT’S Included Door Open Alarm and Forced Door Open AlarmHoliday Setup Duress ModeMain Board Input #2 Buzzer control settingsPower LED Displays the status of the power supply Input #3Cable Selection Termination Resistor in RS-422 Communication Connecting the Termination Resistor and DiodeTermination Resistor Bypass Diode ConnectionHost PC EARTH-GROUNDING the Communication CablesReader Connection POWER, READER, and I/O ConnectionPower Connection Check the location of the power portInput Connection Output Connection Check the location of the communication port RS-232 Pin Female ConnectorCommunication Line Connection RS-232 Communication Port ConnectionRS-232C RS-422 Communication Port Connection StandaloneMAX m SSA-P102 RS-422 Communication Port Connection Multiple UnitsTCP/IP Communication Connection TCP/IP Communication Port ConnectionInitialization Reader Input BIT SetupInitializing the system using the Initialize switch Use the switch to set the valueCommunication Speed Setup Board ID SettingUse the switch to set the value Troubleshooting TroubleshootingProblem Action System is in sync with the PC Service for your helpIrrelevant card number is displayed Properly established D0, D1Product speciﬁcations Product SpecificationsCorrect disposal of batteries in this product