English
Install the tank
BR VS 400 *USA | 6 | |||
|
|
|
|
|
|
|
|
|
|
Place the tank on the cleaner
OPERATION
Fill the tank
Note:
Observe the dosing recommendations of the cleaning agent's manufacturer and mix the cleaning agent solution thoroughly.
Take care when handling cleaning agents!
*Comply with the safety recommendations of the cleaning agent's manufacturer
*Rinse splashes in eyes or on the skin out or off with plenty of clean water
*Call a doctor immediately
*Wash contaminated clothing with water
Open the cap
Fill the tank with the required amount of fresh water
Note:
The maximum water temperature must be 50°C.
–Place the tank onto the cleaner
–Check that the tank is positioned correctly
Fill the tank with the required amount of cleaning agent
–Close the catch
–Use a cloth to wipe away excess liquid that pours out
–Mix the cleaning agent well
Fitting the plug
Connect the plug to the power cable
–Hang the power cable in the strain- reliever
–Plug the cable into the power socket
Set the splash guard
–Undo the fastening screw
–Set the splash guard according to each application.
–Tighten fastening screw.
Note:
Adjust the splash guard parallel to the floor
Turning the pushing handle
–Press the pushing handle downwards and turn to the LEFT or
RIGHT
–Release strain on the pushing handle and turn, it locks in several positions