English
Releasing/locking the pushing
handle
Pull the catch upwards and hold
Tip the pushing handle backwards
Tip the pushing handle forwards;
*The catch locks automatically
Starting/stopping the rotary
brushes
Pull the lower lever;
*Rotary brush drive ON
Release the lower lever;
*Rotary brush drive OFF
BR VS 400 *USA
Measuring out the cleaning agent
Press the upper lever;
*Cleaning agent feed ON Release the upper lever;
*Cleaning agent feed OFF
Note:
The cleaning agent feed is effected only if the brush drive is switched on.
Steering the cleaner
Turn the pushing handle to the LEFT
*Machine moves to the LEFT
Turn the pushing handle to the
RIGHT
*Cleaner moves to the RIGHT
Changing the rotary brushes
–Remove the tank
–Carefully lay the cleaner down
–Always refit two rotary brushes of the same type
Press down and suspend the rotary brushes
Remove the rotary brushes from the gearing
7
–Lay down the rotary brush on the drive side (gearing)
–Dismantle the second rotary brush as described
Fit on a new rotary brush with the gearing located on the drive
–Press the rotary brush down and place it into the thrust bearing
–Install the second new rotary brush as described
–Check that the rotary brushes are in the correct position
–Position the cleaner vertically