Each Time Before Operation, Release both levers

English

EACH TIME BEFORE OPERATION

Working in a lateral direction

BR VS 400 *USA

Switching off the cleaner

–Check the cleaner and especially the power cable for damage

–Checked the rotary brushes for the presence of foreign objects

–Fit the rotary brush that is suitable for the job

–If necessary top up the cleaning agent solution in the tank

–Connect the plug to the power cable

–Hang the strain-reliever

–Plug the cable into the power socket

–Check that there are no obstacles

in the area to be cleaned

*See the Operation Chapter for the description

WARNING!

The cleaner must always be in motion during operation!

Do not work on one spot as this may damage the floor covering!

Do not start an unfilled appliance on delicate floors!

Prior to start-up, tilt unit, activate cleaning agent supply and switch on drive unit for brush rollers.

Pull the catch upwards and hold

Tip the pushing handle backwards

Pull the lower lever;

*Rotary brush drive ON

–Move the cleaner to the LEFT and RIGHT by turning the pushing handle

–At the same time go backwards slowly

–Press the top switch-stirrup as required, the cleaning agent solution is fed to the rotary brooms

Working in lanes

Press the pushing handle downwards and turn to the LEFT or RIGHT

Pull the catch upwards and hold Tip the pushing handle backwards

Pull the lower lever;

*Rotary brush drive ON

–Move the appliance slowly backwards or forwards in long sweeping movements

–Press the top switch-stirrup as required, the cleaning agent solution is fed to the rotary brooms

–Tip the pushing handle forwards; * The catch locks automatically

–When necessary push the pushing handles down and turn back to the

initial position

Note:

Do not leave the cleaner on the rotary brushes