Louisville Tin and Stove DVCF654B-R warranty Lighting Instructions, To Turn OFF GAS to Appliance

LIGHTING INSTRUCTIONS: DVCF403B, DVCF404B, DVCF653B, DVCF654B

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instruc- tions exactly.

B.BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS:

•Do not try to light any appliance.

•Do not touch any electric switch, do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or slide the gas control lever. Never use tools. If the lever will not push in or slide by hand, don’t try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

LIGHTING INSTRUCTIONS

1.STOP! Read the information on the safety label.

2.Set thermostat to lowest setting.

3.Turn off all electric power to the appliance.

4.Remove cabinet door.

5.Push in gas control lever slightly and slide right $￿￿to “OFF”.

	Max. (High)	Gas Control
	Pressure Regulator
		Lever	9.	Slide gas control lever left % to “Set” and hold.
Outlet (Manifold)		NOTE: Knob		Immediately begin a series of pushing and releasing the
				red piezo ignitor button, while observing the pilot through
		can not be
	Pressure Tap			the sight glass. Continue to spark until pilot is lit.
		moved to
				Continue to hold the gas control lever to “Set” for about
		“OFF” unless it
				one (1) minute after the pilot is lit. Release the gas control
		is pushed in
				lever and it will return to “Pilot”. Pilot should remain
		slightly. Do
				lit. If pilot goes out, repeat steps 5 thru 9.
		not force.
			•
				If gas control lever does not return to “Pilot” when
	Step Pressure Regulator			released, STOP and immediately call your service
				technician or gas supplier.
6. Wait five (5) minutes to clear out any gas. Then smell			•
				If the pilot will not stay lit after several tries, slide the
	for gas, including near the floor. If you smell gas, STOP!
				gas control lever to “OFF” and call your service technician
	Follow “B” in the information on the safety label. If you
				or gas supplier.
	don’t smell gas, go to the next step.
			10.	Close sight glass cover.
7. Open sight glass cover.
			11.	Slide gas control lever right $ to “ON”.
8. Locate red piezo ignitor button on side of gas control.
			12.	Replace cabinet.
	Locate pilot behind sight glass. (Follow metal pilot tube
			13.	Turn on all electric to the appliance.
	from gas control).
			14.	Set thermostat to desired setting.

TO TURN OFF GAS TO APPLIANCE

1.Turn thermostat to it’s lowest setting.

2.Turn off all electric power to the appliance if service is to be performed.

3.Remove cabinet door.

4.Push in gas control lever slightly and slide right $ to “OFF”. Do not force.

5.Replace cabinet door.

Page 8