Superior DR500 manual Maintenance Schedule, Maintenance Task Accomplishing Person Procedure

Maintenance Schedule

Annually (Before the onset of the Burning Season)

Maintenance Task		Accomplishing Person		Procedure
Inspecting/Cleaning Burner, Logs		Qualified Service Technician	Inspect valve and ensure it is properly operating.
and Controls			Check piping for leaks. Vacuum the control
			compartment, fireplace logs and burner area.
Check Flame Patterns and Flame Height		Qualified Service Technician	Refer to Figure 7 (D, DT, DR-500), 8 (D,
			DT,DR-600) or 9 (D,DT,DR-800) on page 7
			and verify the flame pattern and height displayed
			by the appliance conforms to the picture. Flames
			must not impinge on the logs.
Inspecting/Cleaning Pilot and Burner		Qualified Service Technician	Refer to Figure 10 (SIT Millivolt), Figure
			11 (Honeywell Millivolt) or Figure 12 (Elec-
			tronic) on page 8. Remove any surface
			build-up on pilot and burner assembly. Wipe
			the pilot nozzles, ignitor/flame rod and hood.
			Ensure the pilot flame engulfs the flame
			sensor as shown.
Checking Vent System		Qualified Service Technician	Inspect the vent system at the top and at the
			base (within the firebox) for signs of blockage
			or obstruction. Look for any signs of disloca-
			tion of the vent components.
Appliance Checkout		Qualified Service Technician	Perform the appropriate appliance checkout
			procedure detailed in this manual.
Replacing Rockwool Ember Materials		Homeowner/Qualified Services Technician	Remove old ember materials and vacuum the
			screened rockwool placement area. Place new
			rockwool as described in this document.
Periodically (After the Burning Season)
Maintenance Task		Accomplishing Person		Procedure
Cleaning Firebox Interior	Homeowner			Carefully remove logs, Rockwool and volca-
				nic stone if used. Vacuum out interior of the
				firebox. Clean firebox walls and log grate.
				Replace logs, Rockwool and volcanic stone
				as detailed in this manual.
Check Flame Patterns and Flame Height	Homeowner			Refer to Figure 7 (D, DT, DR-500), 8 (D,
				DT,DR-600) or 9 (D,DT,DR-800) on page 7
				and verify the flame pattern and height dis-
				played by the appliance conforms to the picture.
				Flames must not impinge on the logs.
Checking Vent System	Homeowner			Inspect the vent system at the top and at the
				base (within the firebox) for signs of block-
				age or obstruction. Look for any signs of
				dislocation of the vent components.
Cleaning Front Glass Enclosure Panel	Homeowner			Clean as necessary following the directions
				provided in this manual. DO NOT TOUCH OR
				ATTEMPT TO CLEAN GLASS WHILE HOT.

5